Partial restoration of plaster

When repairing residential premises, there is often a situation when damage occurs on the surface of the plaster. Even inexpensive country houses sometimes require refreshing cosmetic repairs, not to mention bringing them to a beautiful form. To eliminate the defect, first, the old layer is removed using a tool with a sharp edge. In this case, the plaster will need to be removed to the level of the main layer. It is better to use the respirator on this interval of work, so when the old plaster can you form a lot of dust.

If spray and the soil layer look acceptable, then the finishing level of plaster is repaired. To do this, remove the damaged section of the plaster and cover it using the binder. When the site dries, the finishing layer is reinstated.

Then, it is necessary to moisten with water a brush with soft bristles, and smooth the existing irregularities. To make the surface absolutely even, you need a pico grind. A paint or a layer of whitewashing is removed from the walls or partitions. A solution is required, which will be used to finish the areas during re -triggering. The solution is prepared as lime dough, thoroughly mixed with sifted fine sand. For kneading, you can use a drill or a screwdriver with a special nozzle.

To increase the quality of work, the grater is knocked down with some kind of soft cloth. The identified cracks on the surface are initially opened with a spatula or knife, deepening the damage 3-5 mm in the depths. After the surface, it is necessary to moisturize and apply a lime-sand mortar on it, closing a defect with a spatula. Distribute the mortar mass must be in the direction of the perpendicular to the crack line. Next, the surface must be aligned, moving along the crack.

To get a smooth surface of the surface filled with a solution, it is necessary to align it with sandpaper or a special grid.